CHINA FACTORY CS SERIES MARINE BILGE/SEAWATER HAND PUMP,HOT SELLING CS SERIES DIESEL FUEL HAND PRIMER PUMP

CS-20, CS-25, CS-32 series are suitable for pumping fuel oil, lubricating oil, water and other liquids. It has the characteristics of small size, light weight, good self-priming performance, easy installation and use. The CS series hand pump produced by our factory has reasonable design, exquisite materials, simple maintenance, and important parts are treated with anti-corrosion, so it is an ideal marine pump.

1. Before use, remove the oil drain screws on the two side covers and the upper cover, inject an appropriate amount of lubricating oil, and shake the handle until the handle moves freely.

2. When working, the handle should be shaken back and forth at a large angle. A filter should be installed before the pump inlet to prevent dirt from entering the pump, affecting the working efficiency and service life of the pump or even damaging other parts.

3. When installing the pump, check whether the valve set in the upper end cover of the pump is in the correct position, and shake the pump several times to see if there is any abnormality. If it is found to be abnormal, it can be replaced by the factory.

4. The oil seal period of this series of pumps is six months. If it is put on hold for a long time or stopped for a long time, it should be cleaned and re-sealed.